Electrical slip ring

Electric slip ring is a product that integrates the functions of gas slip ring and electric slip ring. It can transmit gas signals, power and other media through a rotating joint. Its working principle is to convert static media sources into dynamic media and provide them to the required components. The air circuit part of the electric slip ring uses stainless steel hard rotors, and the outer shell is treated with aviation aluminum alloy anodes. Each path is isolated by imported sealing rings, and each path is controlled separately without affecting each other’s work. High precision ball bearings are used to support the front and back, and the conductive slip ring wire is connected through the center of the air circuit part through a flange at the back end. This connects the gas slip ring, rotor and the rotor of the electric slip ring. The outer shell is locked by side screws, which effectively connects the stator part and completes the process. The connection between the rotor and stator of the entire structure.

There are many types of hydraulic rotary joints, and their production processes and procedures are different. Each joint manufacturer uses different materials, which is also the key reason for the different prices and quality of products produced by different manufacturers. Some manufacturers use O-rings on the inner surface of hydraulic slip rings, and the material is treated with ordinary 45 steel blackening. This type of product is prone to leakage when under pressure, and the quality is relatively poor. The manufacturing cost is low and naturally cheap. Some manufacturers use ordinary Glay rings for sealing, 45 steel electroplating treatment, which is the most common process, and the service life is not too long. The price is at an average level, SD adopts high-speed steel vacuum treatment, surface alloy layer, high wear resistance, corrosion resistance, and high pressure resistance. The interior uses imported polymer metal powder synthetic materials, which have ultra-high wear resistance and a service life of up to 8 years. Of course, the manufacturing cost is high, and the selling price is naturally higher than that of ordinary manufacturers. There is no such thing as a high price for no reason. The determination of the selling price comes from the cost of the product. High quality rotary joint products can make users feel at ease and comfortable without maintenance. The product often needs maintenance, but in fact, the maintenance cost is higher than the ordering cost. Therefore, when choosing rotary joints, we cannot only look at the price, but also need to pay attention to the quality of rotary joints, especially the quality of hydraulic high-pressure rotary joint products. We should pay more attention to it because the product quality is poor. There may be issues with usage alone, We need to pay more attention to safety. If high-voltage products burst, the consequences can be quite serious, which will seriously damage the safety of equipment personnel. Therefore, when choosing a rotary joint manufacturer, if it is used for a long time, it is not recommended to replace it because it is cheap. The product is stable and can quickly improve the efficiency of the equipment, greatly reducing maintenance costs.